Nice decor to hold a photo. Get a photo of your spouse, or you two together, or maybe that adorable furr ball you have in your house. Should work like a charm as a Valentine's day gift.
Fits a 10 x 10 cm picture inside. Easy assembly.
General info
2 print plates: One for the Main frame, one for the rest of the pieces.
All parts prints in place.
For the best result on the top surfaces, please use a calibrated flow rate for your filament.
Pieces
Main frame with heart and text
Back wall (largest rectangular piece)
Bottom piece for back wall (smaller rectangular piece)
Support stand (rectangular C-type piece with hooks)
Assembly
Bottom piece
Push the piece in its matching slot in the back of the Main frame, with the small extrusion facing out.
The piece has a nift fit. Push it all the way it can go.
Back wall
The piece has a notch on one side, point it towards the bottom.
Slide the extrusions of one side (f.e. the left side) in the matching slots of the Main frame.
Bend the whole Back wall just enough to slide in the extrusions on the other side to their matching slots.
After both sides are attached, wiggle the back wall from side to side and up and down so it will find its final position.
The notch at the bottom should match the small extrusion of the Bottom piece nicely.
Support stand
Squeeze the ends of the piece to fit it in the matching hole in the lower part of the Main piece.
The piece has a loose fit to the hole. It will find its final position when you let the Main frame lean on it.
